About MD SABBIR BIN ZAMAN

MD SABBIR BIN ZAMAN · 2017-02-11

Posted on February 11, 2017 at 09:10Hello All,I am using a single channel for AD Conversion from an analog front end on STM32L76. But I want a specific sampling rate of ADC. Currently, I am achieving this by using a timer enabling conversion at the ...

MD SABBIR BIN ZAMAN · 2017-01-17

Posted on January 18, 2017 at 03:55I am using stm32cubeMx to generate initialization C code for programming STM32L476RGTx MCU using Keil IDE. Recently, I need to interface an AD5262 digital potentiometer to control the gain of an amplifier automatic...

MD SABBIR BIN ZAMAN · 2016-12-19

Posted on December 20, 2016 at 05:24I was working with STM32L476RGT6. The IDE used for programming was Keil and initialization was done by stm32cubemx. I was using stm32L4 discovery kit to externally program the MCU and STLINK was connector was remo...

MD SABBIR BIN ZAMAN · 2017-02-11

Posted on February 11, 2017 at 09:12Solved the problem. I transfered (uint8_t)1 using 8 bit spi transmission and then I transfered (uint8_t)wiperposition

MD SABBIR BIN ZAMAN · 2016-12-22

Posted on December 22, 2016 at 18:53#SolvedThe problem is solved. The time MCU was originally working because the 20K resistor connected to Boot0 pin was not soldered previously-which I figured out later from reference manuak. The Boot mode was then...

MD SABBIR BIN ZAMAN · 2016-12-20

Posted on December 20, 2016 at 09:42Thank you for your suggestion.Can you explain a little bit, how should I start debugging reset vector in Keil? Thanks in advance

User statistics

User Activity

how to select ADC sampling rate and calculate from stm32cubemx

Idea needed for 9 bit spi transfer using HAL Library

STM32L476, application not running. Help needed for debug?

Re: Idea needed for 9 bit spi transfer using HAL Library

Re: STM32L476, application not running. Help needed for debug?

Re: STM32L476, application not running. Help needed for debug?