About loibl2

loibl2 · 2013-05-14

Posted on May 14, 2013 at 19:05Hello,I want to get the SPINFamily Evaluation Tool (L6480) working but everytime I get an error message to make sure the communication board (STEVAL-PCC009V2) is connected to the PC and board firmware has been updated ...

loibl2 · 2013-06-03

Posted on June 03, 2013 at 21:43Ok, I will try in the Motor forum.I just supposed to get help in STM32 forum because the STEVAL-PCC009V2 uses a STM32x MCU.Thanks for your share!

loibl2 · 2013-05-22

Posted on May 22, 2013 at 20:05Hello clive1,I still haven't found a solution to my problem.The discussion about the same problem is here [[DEAD LINK /public/STe2ecommunities/mcu/Lists/motor_control/Flat.aspx?RootFolder=/public/STe2ecommunities/mcu/L...

loibl2 · 2013-05-15

Posted on May 15, 2013 at 19:08Thank you for your fast reply =)I'm using Win7 32Bit, tried is already on virtualized WinXP 32Bit because I can not even install the driver on an x64 architecture. At the moment I am setting up an old Win2000 system.Th...

loibl2 · 2013-04-20

Posted on April 20, 2013 at 12:37Same problem here, the IBUUI updater just stucks between bullet point ''Connect to board'' and ''Switch to DFU mode''.Switching to DFU onboard does not matter anything...

loibl2 · 2013-04-19

Posted on April 19, 2013 at 22:09Hello goncharov,I had a similar problem with the 64-bit architecture on the STEVAL-PCC009V2 board. I have not found any drivers for this OS, but i solved the problem by setting up a virtualisation OS with VMware.

User statistics

User Activity

SPINFamily Evaluation Tool + STEVAL-PCC009V2 + EVAL6480H R1.1

Re: SPINFamily Evaluation Tool + STEVAL-PCC009V2 + EVAL6480H R1.1

Re: SPINFamily Evaluation Tool + STEVAL-PCC009V2 + EVAL6480H R1.1

Re: SPINFamily Evaluation Tool + STEVAL-PCC009V2 + EVAL6480H R1.1

Re: STEVAL-PCC009V2 firmware reflash

Re: Software for STEVAL-PCC009V1 and EVAL6470H