About hibiscusblau

hibiscusblau · 2013-03-01

Posted on March 01, 2013 at 13:37Hi, I'm new in that technology and this microcontroller. I want to program my zigbee module in order to send me a ''hello world'' message through UART. I have connect my module with STM32W108 ucontroller with a dsPIC...

hibiscusblau · 2013-03-20

Posted on March 20, 2013 at 13:36 Also, my configuration of the UART is: U2MODEbits.UARTEN = 0; // Step 1 U2BRG = 129; // Baud Rate Register // Step 2 U2MODEbits.USIDL = 1; U2MODEbits.WAKE = 1; U2MODEbits.ABAUD = 1; U2MODEbits.PDSEL =...

hibiscusblau · 2013-03-20

Posted on March 20, 2013 at 13:34 Hello everybody, I've found out my problem, and I've achieved to connect that I wanted. Hardware connections: And the C software part: void ZigPrimerContacte(){ switch (StatP...

hibiscusblau · 2013-03-11

Posted on March 11, 2013 at 13:31Hi, I've done some progresses, my first error is do not supply my zigbee module, the person who advice me, told me is it not necessary. Ok, I reset my dsPIC and I detected (with oscilloscope) the following frame fro...

hibiscusblau · 2013-03-05

Posted on March 05, 2013 at 11:40Andrew, You're in right, maybe I run instead of walk. I'll try to change it. For this reasons, I last night thinking out start my program almost without all the rest of my code. But, maybe I should be test my module ...

hibiscusblau · 2013-03-04

Posted on March 04, 2013 at 13:30Thanks a lot clive1, I'm been carrying out yours advices. In order to do it, I first try with my evaluation board, which I've solded three wires in the pads 20(tx), 21(rx) and 28(gnd) which I've connected to a bord w...

User statistics

User Activity

start STM32W108 module zigbee

Re: start STM32W108 module zigbee

Re: start STM32W108 module zigbee

Re: start STM32W108 module zigbee

Re: start STM32W108 module zigbee

Re: start STM32W108 module zigbee