About hinnalear

hinnalear · 2011-08-22

Posted on August 22, 2011 at 11:33I try to modify code from TSL V.2.4.0 in ''Example01_STM8S207_RC_5k'' for run on STM8S103K3 and STM8S105C6. Test on board STM8S discovery (for STM8S105C6). Follow TSL document to modify code but it not work. LED is ...

hinnalear · 2011-08-23

Posted on August 24, 2011 at 06:33I found my problem. My touch sence button make circuit unstable. When I remove my touch sence. It working properly. (Only STM8S103K3, not on STM8S105C6) Your guide helpfull to debug problem. Thank you very much.

hinnalear · 2011-08-22

Posted on August 22, 2011 at 17:11stm8_tsl_conf.h #define MCU_SELECTION (4) #define TIMACQ (TIM2) #define TIMACQ_CNTR_ADD (0x530C) #define TIMTICK (TIM4) #define LOADREF_PORT_ADDR (GPIOE_BaseAddress) /**< LOADREF pin GPIO base ...

hinnalear · 2011-08-22

Posted on August 22, 2011 at 17:05I recheck config on STM8S105C6. My configuration some value wrong. Now it's work done. But on STM8S103K3 not work. in debugging sSCKeyInfo[key_number].state .whole = 8 '\b' .b all value is 0 only ERROR is 1. sSC...

User statistics

User Activity

Looking for example code TSL V.2.4.0 for STM8S105C6, STM8S103K3

Re: Looking for example code TSL V.2.4.0 for STM8S105C6, STM8S103K3

Re: Looking for example code TSL V.2.4.0 for STM8S105C6, STM8S103K3

Re: Looking for example code TSL V.2.4.0 for STM8S105C6, STM8S103K3