Posted on May 17, 2011 at 13:19Dear sjo, Finally I have been able to get the watch-point to work with stm32 using amontec jtag. It seems the issues I was getting were due to the cortex m3 getting in an unknown state. thanks for your assistance. -re...
Posted on May 17, 2011 at 13:19Dear sjo, Thanks again for your reply. I agree with you that the monitor command for watch-point is not supported by OpenOCD with-respect-to Cortex M3. However OpenOCD does support setting of hardware watchpoint throu...
Posted on May 17, 2011 at 13:19Dear sjo, Thanks for your suggestion regarding the monitor command. I did try the your suggestion with regards to openOCD (connected to stm32 through amontec JTAG). I am using gdb client (yagarto) for driving openOCD. ...
Posted on May 17, 2011 at 13:19Dear st7, Thanks again for your quick response. I can get the breakpoint-window (for entering watch-points) through the debug menu in the simulator mode. However when I am debugging on the actual hardware (with code i...
Posted on May 17, 2011 at 13:19Dear st7, Thanks for your reply. Could you please elaborate as to which Menu-option in Keil, should I use for setting hardware data watch-points (read, write OR access). My intention is to set an access watchpoint dat...
