Posted on July 09, 2008 at 04:43Hi Mirco. recently I changed the Interrupt driver into: : while ( CAN1IP1 || CAN1IP2 || CAN1IR ) { . . // Check status interrupt . . if(CAN1IR & 0x8000) . . { . . . . ... . . } . . else . . { . . . . // Start over, ma...

Posted on July 03, 2008 at 09:41when I connect 2 masters to 1 slave (CANbus network), sometimes the slave miss a msg. I think the CAN1IR shows the highest priority and miss the lower one. Does CAN1IR acts like a FIFO? what happen if when my interrpu...

Posted on December 26, 2007 at 09:04Hi all. I have a very strage behavior (VUDU) when I compare 2 MCUS: - ST10 (64MHz, code IFLASH, data XRAM) - C167CR (32MHz, code Ext-Flash, data Ext-RAN) when executing ''float f = tan(3.5);'', - ST takes ~350 uSe...

Posted on May 07, 2007 at 07:02Thanks. Second Q: Can I run from Xflash and program It? (probably no, but what can lose?) Ran

Posted on May 07, 2007 at 05:47Hello all. I was wonder whether can I program Xflash while running from protected I-Flash. Thanks. Ran