Posted on October 26, 2004 at 13:32My customers ST10F276 hardware runs on 48 Mhz. Does someone know how to setup the required 1 wait-state for the XFLASH ? Does someone know the program execution speed difference between IFLASH and XFLASH ? thx, tom...
Posted on October 06, 2004 at 06:18Daniev, just a hint when writing some flash driver SW for the 276 : ST did not meet the timing for IFLASH/XFLASH specified in the datasheet some months ago (BEA stepping). That's the case for writing and erasing as...
Posted on September 22, 2004 at 10:07I have to use P6.2 as discrete I/O. The bus interface is configured for using two CS-signals therefore the P6.2 port pin should be available. Register RP0H is 0x00e2, so bus-cfg should be ok. When I try to access...
