FAQs
Zarck.zek
Associate II
since ‎2018-07-19
‎2023-06-14

User statistics

  • 11 Posts
  • 0 Solutions
  • 0 Kudos given
  • 1 Kudos received

User Activity

Is it possible to get 3d/Cad model of plastic enclosure for STEVAL-BCN002V1B BlueTile ?

2020-06-12
Hi,I'm looking for a CAD model of the BlueTile enclosure which comes with the STEVAL-BCN002V1B boards (see picture)I would like to apply some modification on it for a project, but still get the base of it, if possible.Thank you very much,Best regards...

Get PWM output state for interrupt purposes STM32F215

2018-02-01
Posted on February 01, 2018 at 09:37 Hi, I'm working on STM32F215 and I generate a PWM output on TIM1. This signal is going to an other device. For synchronization purposes on this signal, I would like to get the rising and falling edge of it. ...

Timer PWM change period on runtime

2017-06-12
Posted on June 12, 2017 at 11:17Hi everyone,In my project, I need to generate a PWM with some parameters which need to be changed during runtime.Here are the parameters : - Duty cycle- Period- Voltage level (I think this one is not possible... maybe...

STM32F1 ADC DMA multichannel continuous mode troubles

2016-10-19
Posted on October 19, 2016 at 11:23 Hi everyone, I have troubles getting the ADC working properly. This is my set-up : - STM32F103CB - ADC1 with 8 channels - DMA set on ADC1 I would like to make the conversion of the 8 channe...
Kudos from
View all
Top