About John Smith

John Smith · 2019-12-23

STEVAL-IDB007V1- Virtual COMI have reprogrammed the STM32L151CB on board with the following two file:C:\Program Files (x86)\STMicroelectronics\BlueNRG GUI 3.1.0\Firmware\STM32L1_prebuilt_images\DFU_Bootloader.hex C:\Program Files (x86)\STMicroelectro...

John Smith · 2018-07-04

Posted on July 04, 2018 at 14:05DAHMEN.IMENâ€Œ SIRY.Marc.001â€ŒSTM32CubeMx removes all files from folder during regeneration when Toolchain changedSteps to reproduce.Create new STM32CubeMx project and generate sources as usual:- Open STM32CubeMx -> ...

John Smith · 2019-12-28

Finally found answer to my own questionFor flashing and experiments with BlueNRG-1 chip I used st-link programmer and connected it to CN7 j-tag connector. Then I did not disconnect st-link from board I only unplugged st-link from USB. RESETN signal o...

John Smith · 2018-03-14

Posted on March 14, 2018 at 08:16 Hi ‌ In Stm32CubeMx 4.0 rtc.c generate error are fixed and file are generated normally. But in rtc.c HAL_RTC_MspInit(RTC_HandleTypeDef* rtcHandle) starts to use LL functions, HAL_RTC_MspDeInit() uses HAL functi...

John Smith · 2018-03-13

Posted on March 13, 2018 at 13:54 rtc.c generate error when 'Generate peripheral initialization as a pair of '.c/.h' files' are set in Stm32CubeMx 4.0 Got error when generated RTC initialisation file rtc.c. In Project -> Project Settings -> Cod...

John Smith · 2018-03-13

Posted on March 13, 2018 at 13:27 Hi arietto86‌ As I see, `if(HAL_RTCEx_BKUPRead(&hrtc, RTC_BKP_DR0) != 0x32F2){` line moved up and are called before `HAL_RTC_Init(&hrtc)` function. I think new version is better as it checks if the previous RTC ...

John Smith · 2016-05-04

Posted on May 04, 2016 at 09:48 Hi. I have similar problem with STM32L152RBT6. Generated code is /**Configures for the selected ADC injected channel its corresponding rank in the sequencer and its sample time */ sConfigInjected.Injec...

User statistics

User Activity

BlueNRG-1 STEVAL-IDB007V1 - Virtual COM doesn't work, STM32L151CB stays in DFU mode

STM32CubeMx removes all files from folder during regeneration when Toolchain changed

Re: BlueNRG-1 STEVAL-IDB007V1 - Virtual COM doesn't work, STM32L151CB stays in DFU mode

Re: MX_RTC_Init STM32CubeMX 4.24 error

Re: MX_RTC_Init STM32CubeMX 4.24 error

Re: MX_RTC_Init STM32CubeMX 4.24 error

Re: STM32Cube - BUG report : bug in ADC1 injected channels and bad code generation