No BLE for STM32Wb5x Zigbee_BLE_Dynamic mode
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2025-01-28 1:00 AM
Hello,
I try to test the BLE on my Nucleo-STM32WB55 board.
I use the v1.21.0 ST package for WB boards with BLE_Zigbee_Dyn exemple.
I can use Zigbee without problems, but i never be able to use BLE. I can't discover device on ST BLE sensor classic.
I upload the stm32wb5x_BLE_Zigbee_FFD_dynamic_fw.bin.
Thanks.
Solved! Go to Solution.
- Labels:
-
BLE
-
STM32WB series
-
Zigbee
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2025-01-28 6:08 AM
Hello,
By reading Nucleo logs i identified that i was not able to upload the co-processor M0.
I retry this step and upload correctly the zigbee_ble_dynamic firmware, and be able to access to BLE protocole as Zigbee.
My co-processor was also in static mode.
This subject could be closed.
Thank you.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2025-01-28 6:08 AM
Hello,
By reading Nucleo logs i identified that i was not able to upload the co-processor M0.
I retry this step and upload correctly the zigbee_ble_dynamic firmware, and be able to access to BLE protocole as Zigbee.
My co-processor was also in static mode.
This subject could be closed.
Thank you.
