Wanted To confirm The IDE for the development

Adithya_Jayaram · ‎2023-11-15

Hi we're using STM32L412RB controller for our development wanted to know what are preferable IDE that can be used for the software development for the purchased controller.

STTwo-32 · ‎2023-11-15

Hi again @Adithya_Jayaram

I personally recommend the STM32CubeIDE wish is open-source and will meet perfectly your needs. If you are looking for other IDE, I suggest you use Keil and IAR for your project (both are under license).

Best Regards.

STTwo-32

To give better visibility on the answered topics, please click on Accept as Solution on the reply which solved your issue or answered your question.

View solution in original post

STTwo-32 · ‎2023-11-15

Hello @Adithya_Jayaram and welcome to the ST Community.

I advise you to use the last versions of STM32CubeIDE (all-in-one multi-OS development free tool) and CubeMX

(a graphical tool that allows a very easy configuration of STM32 microcontrollers).

Best Regards.

STTwo-32

To give better visibility on the answered topics, please click on Accept as Solution on the reply which solved your issue or answered your question.

Adithya_Jayaram · ‎2023-11-15

Any other IDE's? other than STM, please give me couple of options so I could check if i can get the license for the same(as it's a corporate project have to get the license for the same so need options ).

STTwo-32 · ‎2023-11-15

Hi again @Adithya_Jayaram

I personally recommend the STM32CubeIDE wish is open-source and will meet perfectly your needs. If you are looking for other IDE, I suggest you use Keil and IAR for your project (both are under license).

Best Regards.

STTwo-32

To give better visibility on the answered topics, please click on Accept as Solution on the reply which solved your issue or answered your question.

Adithya_Jayaram · ‎2023-11-30

Hi , we're suggested to use eclipse, just wanted to know is it compatible with STM32L412RBT6P.

Southbranch · ‎2023-11-30

Good questiion,

I am using CubeIDE but I plan to test out Viusal Studio Code with the add-in for STM32. Has anyone tested this, pros and cons? What about pin-configuration possibilites?