P-NUCLEO-IHM002 doesn't run
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2021-02-05 1:38 PM
I have a brand new P-NUCLEO-IHM002 out of box. I configured it according to the instruction. however, when power up, D11 on IHM07M1 is not light at all. when i push the blue button, no response. LD3 on Nucleo-F302R8 is on, LD1 is flashing. Can you help me to debug?
Thank you.
Shengnan
Solved! Go to Solution.
- Labels:
-
STM32F3 Series
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2021-02-08 10:52 AM
Reprogram the firmware.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2021-02-07 11:30 AM
Problem solved.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2021-02-08 7:40 AM
Hello @SLi.11​ and welcome to the STM32 Community :)
Could you please share how you solved your issue ?
Then, mark your answer as "Best Answer" by clicking on the "Select as Best" button, this can be very helpful for Community users to find this solution more quickly.
Imen
Thanks
Imen
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2021-02-08 10:52 AM
Reprogram the firmware.
