cancel
Showing results for 
Search instead for 
Did you mean: 

Microcontroller selection

research
Associate
Posted on May 26, 2017 at 07:07

Hello,

I am developing one application with high speed inputs and outputs.

Peripheral requirement for application are as below:

1. 4 PWM output with resolution 32bit and 2MHZ clock OR external clock source for PWM with 32bit resolution

2. 8 external interrupt pins. Dedicated interrupt request for each interrupt

3. One UART(for programming)

4. One I2C (100kHz)

5. Clock source : external crystal support, clock should be higher than 40MHz.

6. Pin count : 32 to 48

7. Flash : 32kB to 128kB

Is any microcontroller available with these features?

1 ACCEPTED SOLUTION

Accepted Solutions
Amel NASRI
ST Employee
Posted on May 26, 2017 at 15:21

Hello

Kumbhar.Mukund

‌,

There is a large selection of STM32 microcontrollers which may answer your request.

I recommend you to use the 'MCU Finder' tool (

http://www.st.com/content/st_com/en/products/development-tools/software-development-tools/stm32-software-development-tools/stm32-utilities/st-mcu-finder.html

,

http://www.st.com/content/st_com/en/products/development-tools/software-development-tools/stm32-software-development-tools/stm32-utilities/st-mcu-finder-pc.html

or the one embedded in

http://www.st.com/content/st_com/en/products/development-tools/software-development-tools/stm32-software-development-tools/stm32-configurators-and-code-generators/stm32cubemx.html

) to fine tune your choice and the select the suitable one(s).

-Amel

To give better visibility on the answered topics, please click on Accept as Solution on the reply which solved your issue or answered your question.

View solution in original post

2 REPLIES 2
Amel NASRI
ST Employee
Posted on May 26, 2017 at 15:21

Hello

Kumbhar.Mukund

‌,

There is a large selection of STM32 microcontrollers which may answer your request.

I recommend you to use the 'MCU Finder' tool (

http://www.st.com/content/st_com/en/products/development-tools/software-development-tools/stm32-software-development-tools/stm32-utilities/st-mcu-finder.html

,

http://www.st.com/content/st_com/en/products/development-tools/software-development-tools/stm32-software-development-tools/stm32-utilities/st-mcu-finder-pc.html

or the one embedded in

http://www.st.com/content/st_com/en/products/development-tools/software-development-tools/stm32-software-development-tools/stm32-configurators-and-code-generators/stm32cubemx.html

) to fine tune your choice and the select the suitable one(s).

-Amel

To give better visibility on the answered topics, please click on Accept as Solution on the reply which solved your issue or answered your question.

Posted on May 26, 2017 at 21:55

Most of the parts only support external crystals to 25-26 MHz, but will take an oscillator source of 50 MHz, check fHSEmax in the Data Sheet.

The EXTI pin interrupts frequently go to a single dispatch point, but the source can be identified and vectored quickly.

Four 32-bit PWM sharing a common clock/period is achievable in a number of parts, and rates well north of 2 MHz.

F401?

Tips, Buy me a coffee, or three.. PayPal Venmo
Up vote any posts that you find helpful, it shows what's working..