MC SDK v6.2.0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2023-10-18 5:50 AM
Hello,
I am trying to use the MC SDK v6.2.0 for controlling a PMSM and I wish to control the motor through my host PC with uart protocol
I have got below document which is for SDK v4.3.
Can you please share similar user manual for SDK v6.2.0
Can you also share references to read the encoder angle and speed control
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2023-10-18 6:07 AM
hi @shraddhs10 ,
All the information you need can be found at this link:
MCSDK documentation and your feedback - STMicroelectronics Community
in the Documentation embedded in the MCSDK .
Regards
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2023-10-18 6:07 AM
hi @shraddhs10 ,
All the information you need can be found at this link:
MCSDK documentation and your feedback - STMicroelectronics Community
in the Documentation embedded in the MCSDK .
Regards
