I am using STM32nucleof446re board and using freeRTOS as third party.I made two simple tasks which used printf statement that "task1/2 is running ".But when I want to debugge mode and started tracing then I am unable to see anything on ITM console.

SGupt.10 · ‎2021-06-16

I also set debug settings like enable SWV,clock frequency (84Mhz),0th bit etc.

But no luck .Please do needful.

Walid ZRELLI · ‎2021-06-28

Hello @SGupt.10 ,

Take a look at this video : https://www.youtube.com/watch?v=sPzQ5CniWtw

It might help you .

BeST Regards,

Walid

I am using STM32nucleof446re board and using freeRTOS as third party.I made two simple tasks which used printf statement that "task1/2 is running "​.But when I want to debugge mode and started tracing then I am unable to see anything on ITM console.

I am using STM32nucleof446re board and using freeRTOS as third party.I made two simple tasks which used printf statement that "task1/2 is running ".But when I want to debugge mode and started tracing then I am unable to see anything on ITM console.