Due to the poor delivery date of STM32F205VET6, the gerbers were assembled using STM32F205ZET6 as a substitute.
The Gerber data is connected to the equivalent pins of the STM32F205VET6 and STM32F205ZET6, with unused pins dropped to ground.
I have done the specification as per the attached Gerber data, but I am getting abnormal values from the measured values output from CN101.
Also, the power values output from CN5 and CN12 are different from the expected ones.
If we use parts like this Gerber data, is it necessary to revise the software? I would be grateful if someone could give me some advice.
