Dear community member, The “Analog and audio” topic is no longer supported on the ST community. The legacy content is available only by the read-only basis. If you have any requests regarding "Analog and audio” topics, check the alternative support ...
We want to utilize the diode STTH3003. It would be great to have some information about the dielectric strength of the plastic material.Is this information available?Thanks and best regards!Markus
One of the sample devices required is the STA540 amplifier. It seems to be a good device which will allow students to work with quad, stereo, and bridged outputs.
Hello!I want to ask you some advice in building a class D amplifier using the integrated circuit STA516BEFrom the information provided by the integrated datasheet, I am misled by some features.I want to use figure no. 8 (dual BTL) for speakers with a...
Dear ST support teamAs shown in the diagram, I use a current transformer (PT1) and an amplifier to measure AC voltage:When U1A is LM258DR of TI, the system works perfectly well. After replacing U1A with LM258DT of ST, the waveform measured by the osc...
The M41T62 driver provided in STSW-M41T62 appears to have an error related to calibration of positive adjustments. Refer to the code below from line 750 of M41T62.cThe sign parameter is 0 or 1. To program the M41T62 for positive compensation requires...
I have just bought the STEVAL-IME009V1. It comes with a factory settings DFU file and DfuSe evaluation tool (STSW-STM32080).It generates and extracts hex files, but how can I edit those files to create impluses and burst pulses with specific frequenc...
