About AnthonyK

AnthonyK · 2025-03-27

Hello,I am trying to run a BLDC motor using the MC control SDK. The BLDC motor is the following: BLDC 40P30F16P2.063D by MinebeaMitsumi. First, I entered its parameters in MC Workbench + made the profiling for its mechanical parameters, however this ...

AnthonyK · 2025-03-31

Good Morning, Just for updates, I was able to run the profiler for the hall sensors and it worked. The FOC now with Hall effect sensors is running but the weird thing is that I needed to switch hall sensors H1 and H2 (I knew because of the profiling,...

AnthonyK · 2025-03-28

Well I tried several times with that and everytime I get Speed feedback error; I tried to tune the C2 gain as recommended and it is not working. In addition, in the rev-up table, I cannot set anything the values keep on going back to zero I dont know...

AnthonyK · 2025-03-28

Well, the current control loop is ok (I tuned using Open Loop Current). But when I get to the speed, this where the things are strange. I have attached the evolution of the elecrical angle when I turn the motor by hand (few degrees) and that's what I...

AnthonyK · 2025-03-27

No it is my bad sorry. I got confused between the two also

AnthonyK · 2025-03-27

Thank you for your reply. I followed this topic: Solved: Is this a 120 or 60 deg displacement angle hall mo... - STMicroelectronics Community that's why I thought it is 120 degrees. In the manual it is written as you have said in your post. I tried w...

User statistics

User Activity

Motor won't turn in closed loop FOC with using MC Control SDK and hall sensor

Re: Motor won't turn in closed loop FOC with using MC Control SDK and hall sensor

Re: Motor won't turn in closed loop FOC with using MC Control SDK and hall sensor

Re: Motor won't turn in closed loop FOC with using MC Control SDK and hall sensor

Re: Motor won't turn in closed loop FOC with using MC Control SDK and hall sensor

Re: Motor won't turn in closed loop FOC with using MC Control SDK and hall sensor