Hello,I am having trouble measuring current with the L99615C STEVAL kit and wanted to check if I might be doing something wrong. My jumper settings are as follows: J19, J20, J13, and J14 are shorted, while J15, J16, J17, and J18 are set to position 1...

Hello,I’m encountering an issue where I’m unable to fully understand the behavior of the GUI in relation to the commands being transmitted via serial USB to the NUCLEO. I’ve figured out that there is a CRC at the end of the raw data being transmitted...

Hello,I am currently working with the STEVAL-L99615C evaluation kit and the Nucleo G071RB microcontroller board. My goal is to set up a LabVIEW program that can:1. Adjust the output voltages of power supplies to simulate real battery cells.2. Read da...