About ronaksm

ronaksm · 2025-01-08

Moved from 'Feedback' forum - which is reserved for posts about the forum itself.I am simply trying to blink onboard LED on PC13. When I run without any breakpoints the stack looks as follows:I have 2 bluepill boards and the result is similar on both...

ronaksm · 2025-01-08

Found the problem: The Boot0 pin had to be kept at 0 even for debugging and then it worked. I don't know whether such setting is as expected.

ronaksm · 2025-01-08

It is indeed a F103C6 and I had created a completely new project with F103C6. However, the stack is still the same. Additionally, I have placed the breakpoint in SysTick_Handler and the PC never jumps to that address. Is there any other setting in Cu...

ronaksm · 2025-01-08

When I single step, the LED turns OFF from ON condition. HAL_Delay() -> HAL_GetTick() are the last set of functions that I am able to single step. I have further debugged and it seems the uwtick variable is not getting updated. It always remains zer...

ronaksm · 2025-01-08

I am using Stm32CubeIDE. Below is the simple code that I am trying to run.int main(void) { /* USER CODE BEGIN 1 */ /* USER CODE END 1 */ /* MCU Configuration--------------------------------------------------------*/ /* Reset of all periph...

User statistics

User Activity

Stm32f103CbTbA Bluepill board "<signal handler called>() at 0xfffffff9"

Re: Stm32f103CbTbA Bluepill board "<signal handler called>() at 0xfffffff9"

Re: Stm32f103CbTbA Bluepill board "<signal handler called>() at 0xfffffff9"

Re: Stm32f103CbTbA Bluepill board "<signal handler called>() at 0xfffffff9"

Re: Stm32f103CbTbA Bluepill board "<signal handler called>() at 0xfffffff9"