Dear ST, Do you know amount of is the maximum allowable capacitance on the ~RST output for SR1 reset controller? By tradition we put 0.1 uF on the NRST pin, but is it OK with SR1?We use SR1PBBU with OD output.Thanks in advance!

Dear ST, is it possbile to use LPS22HB as secondary sensor connected to LSM6DS3TR I2C master port with automatic readout of LPS22 registers? If yes, could you please recommend some examples / solution suggetsion on this on the firmware side?Thanks in...

Posted on November 08, 2015 at 23:52 Hi, all! Does anyone faced with a skipping one period of input signal without ovrcapture flag setting? The setup is: * STM32F3 Discovery board with STM32F303 MCU. * TIM2 used for input / c...

Posted on October 20, 2015 at 15:51Hi, all. Could you please recommend the best way to do that using STM32 Timers? Input signal is a 5-10 kHz 3V sine-wave, and high-stable TCXO 12 MHz is used for MCU clocking. Measurement should be done with 1E-3 H...