About kingtama

kingtama · 2015-10-17

Posted on October 17, 2015 at 18:49Hi Community, I was using a NetDuino 2 Board which is just an STM32F205. Since I couldn't get the USB HID device to work correctly I thought I would take a shot at making my own firmware for the board. I created a ...

kingtama · 2016-02-08

Posted on February 08, 2016 at 18:23Just updated to 4.13 of the CubeMX and tried again. Same result. Also I always enabled VBus. I will try it again without VBus and maybe try a few other configurations. Going through the Analyzer everything appears...

kingtama · 2016-02-01

Posted on February 01, 2016 at 19:58I can't believe nobody replied to this. I'm having the exact same problem. I'm using an STM32F205RFx chip however. The HID Code generated from the CubeMX using 4.12.0 works correctly. Although it was very tricky f...

kingtama · 2015-10-20

Posted on October 21, 2015 at 00:27As it turns out my button wasn't working correctly. So pressing it harder made the board go into DFU mode. Your suggestion put me on the right path and was finally able to after trial and error configure the PLL fo...

kingtama · 2015-10-17

Posted on October 17, 2015 at 20:40Hi Clive, Thanks for the reply. Ok, I'll try that. This board has a little button that was used before to put it into DFU mode that I would press and hold while plugging it into the USB. That doesn't appear to be w...

User statistics

User Activity

Re-installing the DFU Firmware on an STM32F205RFT6

Re: usb enumeration errors, new project from cubemx

Re: usb enumeration errors, new project from cubemx

Re: Re-installing the DFU Firmware on an STM32F205RFT6

Re: Re-installing the DFU Firmware on an STM32F205RFT6