About daniele2399

daniele2399 · 2017-05-12

Posted on May 12, 2017 at 11:11 Hi all, I'm trying to use the SPWF04SA module in SPI mode. So far I've managed to put it in such a mode either with the AT commands or just by pulling high the IRQ line, however it seems to be stuck without any res...

daniele2399 · 2017-02-14

Posted on February 14, 2017 at 11:35Hi,I'm using the BlueNRG-MS chipset. As far as I've understood, the connection interval is set through 'aci_gap_set_discoverable' and if the related arguments of the function (SlaveConnIntervMin and SlaveConnInter...

daniele2399 · 2016-12-06

Posted on December 06, 2016 at 15:28Hi,I'm using the Bluenrg-ms chipset with firmware version 7.1.e (0x715). Everything works fine, except from the authorization settings. Each device can connect to the BLE without any request for permissions (PIN)....

daniele2399 · 2015-11-18

Posted on November 18, 2015 at 11:37Hello all, I'm currently working on an STM32F411VEH6 MCU and I'm trying to launch an application located at the flash address 0x08004000 with a bootloader at the flash base address (0x08000000). I've read a bunch ...

daniele2399 · 2017-05-12

Posted on May 12, 2017 at 14:59Hi Gerardo,thank you for the reply. I already checked it out and configuration corresponds. As soon as the interrupt latches, I try to read out the 5 bytes header but cannot find the 0x02 sync word anywhere. Then the i...

daniele2399 · 2016-12-07

Posted on December 07, 2016 at 10:24Hi Andrea,thanks a lot for the quick reply, I'll give it a try soon but it seems already more clear.Ciao,Daniele

daniele2399 · 2015-11-20

Posted on November 20, 2015 at 11:55Thanks for your suggestion, I succeeded in running the app after setting the vector table address as well as the flash base address correctly. Ciao, Daniele

daniele2399 · 2015-11-18

Posted on November 18, 2015 at 21:42Sorry if I wasn't clear enough, probably it's my understanding of the point which is missing. I'll be back with some updates soon... Thank you, Daniele

daniele2399 · 2015-11-18

Posted on November 18, 2015 at 18:08Thank you for the quick reply. I omitted to say that I commented the conditional expression for *(__IO uint32_t*) MCU_FLASH_GetAddress(APPLICATION_SECTOR) gives 0x20020000 as result and the expression wouldn't re...

User statistics

User Activity

SPWF04SA SPI interface

BlueNRG-MS connection interval

Bluenrg-ms bonding with PIN

STM32F411 IAP

Re: SPWF04SA SPI interface

Re: Bluenrg-ms bonding with PIN

Re: STM32F411 IAP

Re: STM32F411 IAP

Re: STM32F411 IAP