About zax

zax · 2025-01-23

Hi,I am using stm32WB5MM, I have bootloader which is located on regular start address 0x8000000.Bootloader executes image which is located on some other location (location is divisible by 0x400 as required).For that image I changed linker file and xx...

zax · 2024-10-11

Hi,I tried to flash stm32wb5mm-dk board with cubeProgrammer with image of 900kB. I am getting error message " Sector Erase operation has failed at least for one of the specified existing sectors"These are my settings of memory protection:When I try s...

zax · 2025-01-27

any help?

zax · 2024-10-16

Thanks for clarification.When I try reading of sfsa it is set to 0x00.Can you try to set SFSA byte to 0xE2 on your side. When I try, I get error: Option byte programming failed:Do I need to set some other option so this one can be set?These are my de...

zax · 2024-10-16

Hi,I can't change onboard st-link because it's official development kit, but I will try with J-link debugger when I get tag-connect connector.Thanks

zax · 2024-10-16

Hi,With older version of stm32CubeProgrammer (2.10.0) I am able to set option bytes, but other problems are still present.

zax · 2024-10-15

Did you find any solutions for this? I have the same problem for stm32wb5mm dk

User statistics

User Activity

STM32WB5MM CPU2 bootup issue if image of CPU1 is relocated

Error during flashing STM32WB5MMGH6U with cubeProgrammer.

Re: STM32WB5MM CPU2 bootup issue if image of CPU1 is relocated

Re: Error during flashing STM32WB5MMGH6U with cubeProgrammer.

Re: Error during flashing STM32WB5MMGH6U with cubeProgrammer.

Re: Error during flashing STM32WB5MMGH6U with cubeProgrammer.

Re: Not able to update option bytes