About Scopi

Scopi · 2025-01-02

Hi there,I cannot seem to enable a hall sensor or quadrature encoder in motor control workbench.Motor control board: X-NUCLEO-IHM08M1MCU: NUCLEO-G474REMC workbench version: 6.3.2CubeMX version: 6.13.0I have checked the 'connectionparameters.json' fil...

Scopi · 2025-01-03

Confirmed; creating a new workbench and associated stwb6 file with the same options, and all is well.I had been opening the .ioc file with motor control workbench and making changes / generating code, and as it seemed to be working & the changes were...

Scopi · 2025-01-03

Hi Fouad,This may be the issue. There is no .stwb6 file. The project was copied into git at some point and that file did not come across. I'll try making a new project from scratch, and if the same issue presents I'll post back in this thread with th...

Scopi · 2025-01-03

Hi Fouad,I've attached the .ioc file, is there any other file that might be of use?

Scopi · 2025-01-02

Hi Gael, Was there any progress on this?We're about to implement the same encoder as DAlvarez, and though I'm sure it can be done any hints towards an easier path would be greatly appreciated.Cheers,Scott

Scopi · 2024-10-10

You just saved me a lot of time. Thanks!To anyone else following along - the file to edit is (in the case of the stm32mp153d)stm32mp153d-stm32mp153d_initial-mx.dts

User statistics

User Activity

Quadrature Encoder/Hall Sensor greyed out in Speed Sensing Selection

Re: Quadrature Encoder/Hall Sensor greyed out in Speed Sensing Selection

Re: Quadrature Encoder/Hall Sensor greyed out in Speed Sensing Selection

Re: Quadrature Encoder/Hall Sensor greyed out in Speed Sensing Selection

Re: Feature request: spi encoder

Re: BUG: Label or path X_pins_y not found - Compiling the TF-A firmware