About netanelu

netanelu · 2024-03-19

I received my first STM32WB5MM-DK.Reeded AN5289 first 104 pages to understand the architecture of the examples.And watched this youtube playlist "STM32WB Getting Started Series". So after importing the Heart Rate example with cubeIDE (Version: 1.14....

netanelu · 2022-08-27

Hi,I'm using STM32 family for a very long time for lot of clients. My clients want to use linux system just for the screen and the wifi capabilities and I want to use STM32H7B3I-DK as reference and design cheaper and more stable system (I dont like t...

netanelu · 2019-10-08

Hi,I'm trying to get the heading direction from the compass of LSM303AGR, I'm getting the X,Y,Z data and configured the compass and the accelerometer.I just preform a atan2(y,x) function and not using any filtering or compensations. I wanted to see d...

netanelu · 2019-09-29

It's returning ack on the i2c on every command , and i'm getting an error if it's not the correct address.I'm attaching image from the scope of the i2c commands and responses.The configuration done first and then I'm reading the temperature that it a...

netanelu · 2015-07-22

Posted on July 22, 2015 at 19:03Hi, i have an discovery STM32F407 board, using cubemx (4.9.0), opened new project for the STM32F407 discovery board. enabled USB_OTG_FS ''Device Only'' mode without SOF and without VBUS. Selected the CDC class, the cl...

netanelu · 2024-08-14

Hi, I have the same issue,Wish to run BLE with RTC and calendar to keep track of the time and keep the low power.when i config CFG_RTCCLK_DIVIDER_CONF to 16, the device is advertising and connectable,But once sending read/write request the device stu...

netanelu · 2024-04-24

I just got some errors on this time server and try to figure out stuff,Your code error is simple,uint8_t A = HW_TS_Create(CFG_TIM_PROC_ID_ISR,TEMP_TIMER_ID,hw_ts_Repeated,TEMP_Timer_Callback); should beuint8_t A = HW_TS_Create(CFG_TIM_PROC_ID_ISR,&TE...

netanelu · 2024-04-17

Did you got this error?

netanelu · 2022-12-20

Ok found my problem,SPI set as 4 bit by default :\ (need to be 8)Well, it was a hard start, cube need some gui improvements or I just need a new 30' screen :)

netanelu · 2022-12-20

Please advice,hard reset as re connecting the usb or to set debugger reset behavior type to hardware reset? (none help).and longer reset time?what i need to change to make this example work?

User statistics

User Activity

My first project with STM32WB5MM-DK

Guides\Projects for STM32H7B3I-DK

LSM303AGR heading angle calculation problems.

LSM303AGR return only zeros

usb enumeration errors, new project from cubemx

Re: STM32WB how to use RTC with BLE

Re: STM32wb Hardware time server module(HW_TS) module & sequencer not working

Re: STM32WB5x battery-powered BLE device - missing low power APIs?

Re: X-NUCLEO-IDB05A2 not working, stuck on SPI_Reset on STM32F746ZG

Re: X-NUCLEO-IDB05A2 not working, stuck on SPI_Reset on STM32F746ZG