About jorge

jorge · 2016-03-14

Posted on March 14, 2016 at 19:58Hello,I'm trying to set up a STA311B to send an I2S signal to a DAC. Do you have any sample schematics? My main question is which chip should provide the MCLK signal to the DAC.Also, is it documented what would be th...

jorge · 2015-07-17

Posted on July 17, 2015 at 23:24Hello,I'm setting up a system with a STA309A DSP and a STA510A amplifier.I'm expecting to connect two 8Ω loads with a maximum power of 50W each, but I can't find the graphics that show the estimated Power dissipation ...

jorge · 2016-03-17

Posted on March 17, 2016 at 21:50Thanks YT! That is very helpful. Much appreciated!I'll come back with more questions later 

jorge · 2015-10-05

Posted on October 06, 2015 at 06:26YT,As always, your answers are spot on! A couple of additional questions come to mind:1. If I switch to a STA311B and a STA516B using FFX mode, would that change the formulas and the values I need to use?2. If I us...

jorge · 2015-10-05

Posted on October 06, 2015 at 05:57I'm also very interested in this topic. I wish to connect the headphone output of a STA311B, which I'm assuming would be very similar to the STA309A circuit. In both datasheets the connection is mentioned, but in n...

jorge · 2015-07-20

Posted on July 21, 2015 at 02:27Hello YT,Thanks for your very helpful response.I'm looking at STA518A datasheet and I see in Figure 17 that at 39W, the power dissipation is about 9W. Does that mean that if I use a 28.5V power supply I would need it ...

User statistics

User Activity

Clock circuit for STA311B I2S output - and minimum delay

Choosing a power supply for an ST510A device

Re: Clock circuit for STA311B I2S output - and minimum delay

Re: Choosing a power supply for an ST510A device

Re: STA309A - 2.1 Configuration - L/R PWM + Line-Out Woofer

Re: Choosing a power supply for an ST510A device