Hello @mteaching I suggest you to follow this wiki page to understand how SPI works and how to configure and use it. Especially the device tree configuration in your case:https://wiki.st.com/stm32mpu/wiki/SPI_overview Best Regards, Arnaud
Hello @MScor.1, If you haven't solved your issue yet, I would suggest you to create a new layer at the same level as meta-st-stm32mp-addons by following:https://wiki.st.com/stm32mpu/wiki/How_to_create_a_new_open_embedded_layerNext, you can add your c...
Hello @swaroop,I confirm the EKF is available only with Mickledore. Knowing this, i recommend you to start a new Yocto project with the Mickledore version following: https://wiki.stmicroelectronics.cn/stm32mpu/wiki/STM32MPU_Distribution_Package Then...
Hello @swaroop I assume you followed the user manual "UM2909: Getting Started with X-LINUX-GNSS1" available on: https://www.st.com/en/embedded-software/x-linux-gnss1.html#documentation Looking at 4.2.3.1 Adding EKF into distribution build, you might ...
Hello @Anto_Z Since the build of the recipe might have been abruptly interrupted, you can try to clean it using:bitbake -c cleansstate <recipe>Then build your image again. Best Regards, Arnaud
