About Bhavil

Bhavil · 2024-06-22

Hi,I recently created a custom board based on STM32G030 IC and programmed it via UART to run my application. Now, I want to make some changes to my firmware, but I can not connect to the CubeProgrammer. I have tried connecting it via UART and ST-LINK...

Bhavil · 2024-06-24

Great,So I am better off with Serial-wire debugging while using the same settings then. Thanks a lot for your help.

Bhavil · 2024-06-24

Yupp, Normal and Software reset works too. If possible can you help out with the nBoot bits as well. I would like to reprogram the board using UART, which is not possible at the moment as, I think the code is directly jumping to the firmware regardle...

Bhavil · 2024-06-24

Thanks Ascha,That worked well, now I can access the device using SWD. Pardon me as I am fairly new to STM32 and am a little confused regarding the BOOT select and all the option bytes. I am reading the reference manual and the data sheet but the word...

Bhavil · 2024-06-24

Hi Ascha,Here is the log I get when I try to connect via UARTand this is the log when I try to connect with SWD with Hardware reset. I have pulled up the NRST pin, as I used to get "Target held under reset" error at random times. I did not change the...

Bhavil · 2024-06-23

No issue Peter,Does the SWD work on a brand new chip. If I just unpack and solder a new IC to my breakout board, would I be able to connect to CubeProgrammer via an ST-LINK? While programming via UART, I did enable the the Serial Wire interface as yo...

User statistics

User Activity

Can not connect STM32G030 to CubeProgrammer

Re: Can not connect STM32G030 to CubeProgrammer

Re: Can not connect STM32G030 to CubeProgrammer

Re: Can not connect STM32G030 to CubeProgrammer

Re: Can not connect STM32G030 to CubeProgrammer

Re: Can not connect STM32G030 to CubeProgrammer