About Anesh

Anesh · 2025-02-13

Hello,I am a PowerTrain Electronics Hardware Architect by profession.For one of my new hobby electronics developement I decided to use STM32 micro controller.To start with I bought NUCLEO_F030R8 and able to blink on board LED as I program. Then I tri...

Anesh · 2025-02-16

Hi,As you mentioned O have changed the SWD connections to C7. But I have not used correct GND pin from STLINK-V2/ISOL. I wrongly connected Pin 19 of STLINK-V2/ISOL which is NC. I changed GND to Pin 18 and now I am able to program the Nucleo board wit...

Anesh · 2025-02-13

I provided power to target board (Nucleo) by battery bank and tried. No sucess.I id that because I thought computer may not be able to resolve two usb ports.The LED of the programmer is toglling between Green and Red when it was tried for connection,...

Anesh · 2025-02-13

Both the boards are connected to same computers two USB ports.

Anesh · 2025-02-13

For your reference I have attached few photos.I think NRST of the Target controller must be already connected with onboard STLINK. Even then should I connect it with external programmer (Pin 15 of ST-LINK/V2 ISOL)? At present my oscilloscope is with ...

Anesh · 2025-02-13

Yeah, you are correct. I have used wrong connector. Now I have connected as in the image. But, no sucess :(

User statistics

User Activity

Trying to bypass STLINK/V2-1 on board of NUCLEO_F030R8 and program by external ST-LINK/V2 ISOL

Re: Trying to bypass STLINK/V2-1 on board of NUCLEO_F030R8 and program by external ST-LINK/V2 ISOL

Re: Trying to bypass STLINK/V2-1 on board of NUCLEO_F030R8 and program by external ST-LINK/V2 ISOL

Re: Trying to bypass STLINK/V2-1 on board of NUCLEO_F030R8 and program by external ST-LINK/V2 ISOL

Re: Trying to bypass STLINK/V2-1 on board of NUCLEO_F030R8 and program by external ST-LINK/V2 ISOL

Re: Trying to bypass STLINK/V2-1 on board of NUCLEO_F030R8 and program by external ST-LINK/V2 ISOL