Yes, cable is now detected. Initially, it was not detected after cross verifying the circuit it was observed that the pull ups on RX_DV/MII_MODE and CRS/CRS_DV/LED_CFG were missing and removed some passive components in the circuit.I started debuggin...

Hi Pavel, yes it is.I suppose to use the same controller, as it was decided based on cost.Since the board is ready for bring up, I had no option left rather than continuing on it.I only needed is that, the supported firmware package on which the ethe...

Hi aru,I am working on same MCU for ethernet, but its not working. I want to know which firmware package should be used.Could you please share the firmware package version used? Regards,NaveenK