i use the p-nucleo-ihm006 board to run open-loop mode, it runs well in low speed; but when run in high speed, the motor not run and shake.would you give advice for run high speed in open-loop mode. 

Hi st team,I have purchase the P-NUCLEO-IHM03  development kit, i am using the development as the follows:1, MotorControl workbench 6.2.12, STM32CubeMx 6.10.03, STM32CubeIDE1.14.1 I have try the follow steps:1,In MotorControl workbench 6.2.1 i follow...