About Rajeswari

Rajeswari · 2024-06-22

Hello,I'm trying to do position control using EVSPIN32G4 board and pmsm motor with incremental encoder. I followed the steps given in AN5464. The motor did not move and the rotor is locked. I'm attaching the code here. *******************************...

Rajeswari · 2024-03-25

I am buying a EVSPIN32G4 evaluation board. What are the things I should test or check on the new board for any faults or damages

Rajeswari · 2024-10-20

By enabling potentiometer in MCSDK, i am able to do speed control from Pilot by varying the potentiometer. Is it possible to do position control too? I tried but the shaft doesn't move. Should i do anything to the code?

Rajeswari · 2024-08-11

how u did that

Rajeswari · 2024-08-09

So, I tried the same with a new EVSPIN32G4 board and it works fine now. I am able to do position control using pilot as well as using command from code

Rajeswari · 2024-07-25

I had similar issue. I replaced it with 510 ohm is that ok

Rajeswari · 2024-07-24

Other than cutoff frequency, will it increase the current to MCU pin?

User statistics

User Activity

Position control (based on AN5464) using quadrature incremental encoder(ABZ)

Evaluation Board- EVSPIN32G4

Re: How to write coding for inbuilt potentiometer on EVSPIN32G4

Re: MCSDK 6.3 - Correct way to restart / retrigger encoder alignment

Re: Position control (based on AN5464) using quadrature incremental encoder(ABZ)

Re: EVSPIN32G4 Speed control Issue

Re: Position control (based on AN5464) using quadrature incremental encoder(ABZ)