About Rajeswari

Rajeswari · 2024-06-22

Hello,I'm trying to do position control using EVSPIN32G4 board and pmsm motor with incremental encoder. I followed the steps given in AN5464. The motor did not move and the rotor is locked. I'm attaching the code here. *******************************...

Rajeswari · 2024-03-25

I am buying a EVSPIN32G4 evaluation board. What are the things I should test or check on the new board for any faults or damages

Rajeswari · 2024-07-25

I had similar issue. I replaced it with 510 ohm is that ok

Rajeswari · 2024-07-24

Other than cutoff frequency, will it increase the current to MCU pin?

Rajeswari · 2024-07-22

I have changed the filter resistors from 10kohm to 510 ohm. Will it affect the stspin32g4 IC (any overcurrent drawn)? Why was position control working one day but not the next? I need some solution

Rajeswari · 2024-07-19

you are saying that you are able to do Position control by changing R81/R82/R83 to 330 ohms on evspin32g4 board?I changed it to 510 ohms. will it make much difference?Note: The encoder I'm using has a resolution of 4096ppr.

Rajeswari · 2024-07-19

No, it didn't rotate at MC_StartMotor1(). But I was able to do position control before(default filter resistor 10kohm) using pilot. Now after changing the filter resistors from 10kohm to 510 ohms, I was able to do Position control using code and pilo...

User statistics

User Activity

Position control (based on AN5464) using quadrature incremental encoder(ABZ)

Evaluation Board- EVSPIN32G4

Re: EVSPIN32G4 Speed control Issue

Re: Position control (based on AN5464) using quadrature incremental encoder(ABZ)

Re: Position control (based on AN5464) using quadrature incremental encoder(ABZ)

Re: Position control (based on AN5464) using quadrature incremental encoder(ABZ)

Re: Position control (based on AN5464) using quadrature incremental encoder(ABZ)