About Voklaif

Voklaif · 2025-02-02

Hello,I am using the VL53L8CX sensor on an I2C bus, and it operates normally until I run the i2cdetect command. After running i2cdetect, the sensor stops working properly, and calling vl53l8cx_check_data_ready() returns a GO2 error status.Interesting...

Voklaif · 2025-01-08

I am using the VL53L8CX sensor to measure distances, and I am getting correct values. After some time, the data starts to be sometimes incorrect, while slowly increasing the ratio of incorrect vs correct, until eventually all of the readings are inco...

Voklaif · 2025-02-04

Thank you for the answer John,I think it doesn't have to do with it, since I had a VL53L1X on the bus, and it had no problems with the i2cdetect, they are even on the same 0x29 address. I've also looked at the datasheet of both sensors and the I2C pr...

Voklaif · 2025-01-12

Hi John,Thanks for your reply. You are correct, I've accidently corrupted the data by putting wrong logic in the API file, to protect myself from doing a `memcpy` with a `size` value which is dynamic. My system cannot have any faults as it would be d...

User statistics

User Activity

i2cdetect disrupts VL53L8CX operation, causing GO2 error

VL53L8CX data fakes after some time

Re: i2cdetect disrupts VL53L8CX operation, causing GO2 error

Re: VL53L8CX data fakes after some time