About PadNyammo

PadNyammo · 2024-01-29

I do not have any output via SWV or via COM port debugging using a STM32H723ZGTX.I am using a nucleo ST-link breakoff board to program with no issue.I have tried solutions provided in both following threads:https://community.st.com/t5/other-tools-mcu...

PadNyammo · 2024-02-06

This issue has now been resolved, it was a poor solder connection between the SWO pin and the PCB. This was a simple mistake that I should have caught early on.Thanks AScha.3 for helping out.

PadNyammo · 2024-01-31

I will continue to try your game method, but does anybody else have any suggestions on what I could try?

PadNyammo · 2024-01-31

I am using the ST-link from a NUCLEUS-F401RE board which is ST-LINK/V2-1.I have with a fresh project using only code and async trace setting you instructed tried again following the steps of thegame, still with no luck."+ if try more: have any usb/c...

PadNyammo · 2024-01-31

? I followed your steps word for word. I checked my connections, checked SYS Mode and explained the trace async option was not available but that it was available under debug. I also explained that adding the"int __io_putchar(int ch)" function did no...

PadNyammo · 2024-01-31

If bumping is not correct etiquette on this forum I apologize.I have provided the steps for what I have done, and the results I have observed.Do you have a suggestion for which registers you would like me to check the contents of?

User statistics

User Activity

Unable to get output SWV for debugging on a STM32H723ZGTX

Re: Unable to get output SWV for debugging on a STM32H723ZGTX

Re: Unable to get output SWV for debugging on a STM32H723ZGTX

Re: Unable to get output SWV for debugging on a STM32H723ZGTX

Re: Unable to get output SWV for debugging on a STM32H723ZGTX

Re: Unable to get output SWV for debugging on a STM32H723ZGTX