About Stone1

Stone1 · 2023-10-31

Hi, I'm using STM32G474RET6 for development.When I debug code by SWD, the download verified successfully.But it will be suspended at HAL_Init() and show an error is Break at address "0x1fff5048" with no debug information available, or outside of prog...

Stone1 · 2023-11-08

Hi Tesla,I don't change PA13 and PA14. Could you tell me how to set low power mode?I'm not sure I'm in lower power mode or not.I find it sometimes it can connect and will disconnect suddenly.Thanks.

Stone1 · 2023-11-08

HI Tesla,Yes, I already pulled low the BOOT0.

Stone1 · 2023-11-08

Hello @Imen.D ,The previous issue is solved. But for a while there is another issue.The issue are are the following. I check the BOOT0 pin, and option bits. BOOT0 pin now is connected to GND. I use STM32 ST-LINK Utility to read option bytes as follo...

Stone1 · 2023-11-01

Hi Imen,BOOT0 pin now is floating. Should I tied to GND?I have two same board. The first one can normally work. But the other one met the issue as I mentioned.

User statistics

User Activity

STM32G474 error code

Re: STM32G474 error code

Re: STM32G474 error code

Re: STM32G474 error code

Re: STM32G474 error code