About Spencer_Y

Spencer_Y · 2024-07-03

Hi there,I want to write a bat file to program STM32 MCU.After I issue the command below to erase the full chip.STM32_Programmer_CLI.exe -c port=SWD freq=4000 -e allThe prompt says: 'Mass erase successfully achieved', which indicates the full chip er...

Spencer_Y · 2023-10-18

I need to design an adapter board for STLINK/V2 ISOL. Can I know what is the part number of20-PIN connector used on STLINK/V2 ISOL?

Spencer_Y · 2023-10-18

I need to design an adapter board for STLINK-V3SET. Can I know what is the part number of the STDC14 connector used on STLINK-V3SET

Spencer_Y · 2024-07-07

Hi Kraal,Thanks for you reply.The MCU is STM32H753VIT6TR, and the memory I want to program is external NOR flash (part number: MX25L6433FM2I-08GTR). E: is a local drive. Best regards.

User statistics

User Activity

ST-LINK error after mass erase

What is the part of 20-PIN connector used on STLINK/V2 ISOL

What is the part of STDC14 connector used on STLINK-V3SET

Re: ST-LINK error after mass erase