About yaawl

yaawl · 2023-08-07

I have a question for you. The STM32 F303 processor can be programmed using the UART interface. I have ST-Link/V3 MINIE and V3-Mods and I'm trying to flash the processor using UART (I know it's possible via SWD but I absolutely need UART) After conne...

yaawl · 2023-08-08

I have pins on my board GND / TX / RX / BOOT0 / RST / 3V3. Can you please tell me how i connect this to ST-Link V3 MODS ? My board have RST in HIGH. I dont know what we can use on V3 MODS VCP, CAN or BRIDGE UART ? I plug V3 MODS to the pc, i choose i...

yaawl · 2023-08-07

What do you mean after reset? When connecting to the board or when connecting to target in cube programmer? Because i dont have reset button on the board.

yaawl · 2023-08-07

Thanks for your answer. We have BOOT0 connected to 3.3V during testing. Both BOOT0 and reset are connected to 3.3V. Parities we have sec. Baud rate 115200. Does the BOOT0 always have to be at 1 or only when connecting? thank you for answer. When we t...

User statistics

User Activity

ST-Link/V3 MINIE / V3 Mods UART flash

Re: ST-Link/V3 MINIE / V3 Mods UART flash

Re: ST-Link/V3 MINIE / V3 Mods UART flash

Re: ST-Link/V3 MINIE / V3 Mods UART flash