About mohamed.kamal-fathy

mohamed.kamal-fathy · 2024-07-28

Hello , I have an issue in STM32u575 IN SPI DMA , Even IF I Tried the Example code (/SPI_FullDuplex_ComDMA_Master) there is no data received from the other side iam using the aardvark to test it when check the return of this function HAL_SPI_Get...

mohamed.kamal-fathy · 2023-07-27

Hello, I am trying to Use FDCAN For Nucleo-u575Zi-Q , I already Configured two Stm32 emulation board with the same code one send data and other is receiving data , I did all init Functions and Enable interrupt when receiving data but non of this buf...

mohamed.kamal-fathy · 2024-07-30

Hello Again , Thank you for Your effort I found the issue in software as priority issue there is a lot of tasks and so on that make interrupt does not come so I will solve my project thank you for that

mohamed.kamal-fathy · 2024-07-30

Hello , Finally the example code is working fine but when trying the same steps in my project the function HAL_SPI_TxRxCpltCallback(SPI_HandleTypeDef *hspi) doesn't call any more it means data stuck and never translate may set some points to check ma...

mohamed.kamal-fathy · 2024-07-29

Hello , Thank you for your replay The example code doesn't send any data to the slave when put this line in example HAL_SPI_StateTypeDef test = HAL_SPI_GetState(&hspi1); To check the status it is stuck in HAL_SPI_STATE_BUSY_TX , I don't know why e...

User statistics

User Activity

SPI DMA Doesn't work in Nucleo-STM32u575ZITxQ

FDCAN in Nucleo-U575Zi-q

Re: SPI DMA Doesn't work in Nucleo-STM32u575ZITxQ

Re: SPI DMA Doesn't work in Nucleo-STM32u575ZITxQ

Re: SPI DMA Doesn't work in Nucleo-STM32u575ZITxQ