About FMali.1

FMali.1 · 2022-03-14

Hi,I am currently having trouble with a Hard fault issue that I cannot understand and I was hoping someone might have come across a similar issue. I have a Crystal Oscillator with a 16MHZ clock at the input. I use the MCO pin from the microcontroller...

FMali.1 · 2022-03-14

I also do not need to bypass the HSE. It has to be enabled for external Quartz Oscillator. And that is also correct. But still, why does the clock generated with the inverter of a MCU have an offset of 1.2V. This is what is strange to me. Does the ST...

FMali.1 · 2022-03-14

I am using a STM32F103C8T7 and it supports 16MHz. The PLL multiplier is 3 and all the clock for the peripherals should also be ok. Attached you can see the screenshot with the current clock configuration. Flash latency is set at 1 wait state. I have ...

User statistics

User Activity

Why does the Crystal Clock on STM32F103 have an offset and why is the microcontroller very sensitive to this offset?

Re: Why does the Crystal Clock on STM32F103 have an offset and why is the microcontroller very sensitive to this offset?

Re: Why does the Crystal Clock on STM32F103 have an offset and why is the microcontroller very sensitive to this offset?