About AW.3

AW.3 · 2022-03-03

Hello. I have been getting familiar with the STM32L011F4P6 chip. I am using a 20-pin chip soldered onto a board as my test device. I am using a Nucleo-f429zi as the programming/debug device. I have made the necessary changes and am using the SWD head...

AW.3 · 2022-03-09

After reviewing my 'prepsleep' function and a lot of debugging, I realised that the device was not actually exiting my 'prepsleep' function and not reaching the WFI call (so not entering proper standby).Thank you to JW for assisting with this. For an...

AW.3 · 2022-03-03

I am trying to keep things simple by working on the basis that everything begins at the normal reset values and then I only apply the bare minimum to reach the low current with the WFI call. I agree that GPIOA->PUPDR = 0x24000000 does not seem to be ...

AW.3 · 2022-03-03

Thanks for the quick answer. I have set the DBG_CR bits in my code so they are not used. I am only using the Nucleo board to supply my chip with the VDD and GND pins for my measurements. Should I be using a completely separate power supply?

User statistics

User Activity

STM32L011 how to reach 1uA in standby mode?

Re: STM32L011 how to reach 1uA in standby mode?

Re: STM32L011 how to reach 1uA in standby mode?

Re: STM32L011 how to reach 1uA in standby mode?