About PCond.1

PCond.1 · 2020-03-05

Picture #2: (Current waveform) Operation with resistance added to OUT linePicture #1: (current waveform) Picture when motor does not start Regardless of what values I install for gate resistors (0, 475, 1100 ohm), Vref resistors (8-40K) adding ext fi...

PCond.1 · 2020-03-12

I purchased a new eval board, the VNHD7008AY instead of the '7012. Unmodified, this '7008 eval board had the same issues. I added a large (4700uF) electrolytic at the very input where the BATT signal enters the eval board and the unit overcame the st...

User statistics

User Activity

Using the VNHD7012AY development board to run a brushed 12V motor, I have trouble at initial startup trouble that appears to be a problem with the fault circuitry.

Re: Using the VNHD7012AY development board to run a brushed 12V motor, I have trouble at initial startup trouble that appears to be a problem with the fault circuitry.