About fpaga.1

fpaga.1 · 2022-02-18

I tried to run my motor (PMSM) bit it doesn't run. I used like reference the document:https://www.st.com/content/ccc/resource/technical/document/user_manual/group1/48/e6/91/f4/66/ea/48/a1/DM00490980/files/DM00490980.pdf/jcr:content/translations/en.DM...

fpaga.1 · 2022-01-31

fpaga.1 · 2022-02-18

Hi!Could you share the solution of your problem? I have the same and I don't find any information about this. Kind regards. FRancisco

fpaga.1 · 2022-01-25

Hi, I can't configure the hardware connections in the workbech and in the motor profiler, in which ST program should I configure those parameters before opening the profiler?RegardsFrancisco

fpaga.1 · 2022-01-20

Hi, Also, I have tried to connect the board on ST MOTOR WORKBENCH but it show me the message:RegardsFrancisco

fpaga.1 · 2022-01-20

Hi, I want to connect my STEVAL-esc001V1 to use motor profile, but I receive this error:I have done everything (connecting SWD with Stlink/V2, UART with USB/RS323, install the correct drives and firmware...). ¿Would the problem be the configuration o...

fpaga.1 · 2022-01-20

Hi! Have you found the solution? I have the same problem.

User statistics

User Activity

How to run a pmsm using C-functions of mc_api.c?

I would like to know how to connect three hall sensors with my steval-001v01. I can't find information related. Kind regards Francisco José

Re: How to run a BLDC using C-functions of mc_api.c

Re: Connecting to STEVAL-ESC001V1

Re: Connecting to STEVAL-ESC001V1

Re: Connecting to STEVAL-ESC001V1

Re: Connecting to STEVAL-ESC001V1