About TGUDL.1

TGUDL.1 · 2023-02-26

Hi,I am trying to flash basic Led blinking code. During the flashing, I have seen the error which is attached with this forum. I have double checked the connections.Details of the board: LoRa-E5 Dev Board which has STM32WLE5JC.Debugger: Segger JlinkI...

TGUDL.1 · 2023-03-02

Yes @Wijedn RHIMI. Thank you for the support.

TGUDL.1 · 2023-02-28

Hi,Thanks a lot for the support. Am able to flash the code in the Dev Board. The issue here is during configuration for ADC, one of the pins used for JTAG is misconfigured for the ADC and it causes the JTAG not able to connect the board.Thank you,Mah...

TGUDL.1 · 2023-02-27

Yes, the connections are connected as gnd, vcc, swd, swd, rst from the debugger to the Dev board. Will try the software system reset and update you. Thanks

TGUDL.1 · 2023-02-27

Hi Imen,I am using segger J-Link but not st-link

TGUDL.1 · 2023-02-27

I have connected one end of the debugger (j-link) to PC and other end to the STM32WLE5 Development board (LoRa-E5 Dev Board). The connection looks as below. I am using J-link debugger to flash the code.

User statistics

User Activity

Please help us in resolving the error during Flashing the code i.e. (Error in Final launch sequence). Details are mentioned below.

Re: Please help us in resolving the error during Flashing the code i.e. (Error in Final launch sequence). Details are mentioned below.

Re: Please help us in resolving the error during Flashing the code i.e. (Error in Final launch sequence). Details are mentioned below.

Re: Please help us in resolving the error during Flashing the code i.e. (Error in Final launch sequence). Details are mentioned below.

Re: Please help us in resolving the error during Flashing the code i.e. (Error in Final launch sequence). Details are mentioned below.

Re: Please help us in resolving the error during Flashing the code i.e. (Error in Final launch sequence). Details are mentioned below.