Browse
STMicroelectronics Community
FAQs
Sign In
Product forums
STM32 MCUs
STM32 MCUs Products
STM32 MCUs Boards and hardware tools
STM32 MCUs Software development tools
STM32 MCUs Embedded software
STM32 MCUs TouchGFX and GUI
STM32 MCUs Motor control
STM32 MCUs Security
STM32 MCUs Wireless
STM32 MPUs
STM32 MPUs Products
STM32 MPUs Boards and hardware tools
STM32 MPUs Embedded software and solutions
STM32 MPUs Software development tools
MEMS and sensors
MEMS (sensors)
Imaging (sensors)
Automotive and Transportation
Automotive MCUs
AutoDevKit Ecosystem
GNSS positioning
Edge AI
Interface and connectivity ICs
Power management
ST25 NFC/RFID tags and readers
STM8 MCUs
Others: hardware and software
Analog and audio
Knowledge base
STM32 MCUs
STM32 MPUs
MEMS and sensors
Analog and audio
EMI filtering and signal conditioning
Interface and connectivity ICs
Power management
Quality & reliability
Academy
About
Community guidelines
Feedback forum
Community blog
Developer news
zhn.
Associate II
since
2019-12-27
2023-06-14
User statistics
4
Posts
0
Solutions
0
Kudos given
0
Kudos received
STMicroelectronics Community
About zhn.
Options
Report User
User Activity
Posts
Replies
A problem while using mcu STM32G031J6Mx
2019-12-27
Hello,I use STM32G031J6Mx pin4 as a output. But when I set this pin low, the mcu will be reset.Somebody know why?
Re: A problem while using mcu STM32G031J6Mx
2020-01-06
Thank you,dude.
Re: A problem while using mcu STM32G031J6Mx
2020-01-06
Thx KnarfB,I have solved the problem according to your method.But I still have a question.Why I set this pin as PF2's output with the NRST_MODE=3, the chip will not reset?
Re: A problem while using mcu STM32G031J6Mx
2020-01-06
Please try to set pin4 as PA0，PA1 or PA2's output. Not PF2's. And then set the pin low.Looking forward to your reply!
