About JGonz.1

JGonz.1 · 2020-07-13

Good afternoon,My name is Jorge. I am an firmware engineer from Sayme Corp in Spain.I am using an LSM303AGRTR acceleration and magnetic sensor to get temperature values.I am following the instructions from the datasheet:"4.5 Temperature sensor The LS...

JGonz.1 · 2020-04-06

Hi, I am developing a device that uses the accelerometer/magnetometer LSM303AGR.The problem is that datasheet doesn´t comment about temperature sensibility (For example: Sensitivity = 16 LSB/°C in lis2dtw12)Could anyone give me an equation to convert...

JGonz.1 · 2019-12-12

Actually our device has 33 uA in DC current consumption without accelerometer LIS2DW12, with the LIS2DW12 this previous number increases to 55 uA.I think that it is possible to decrease the current consumption, based of the information of datasheets....

JGonz.1 · 2019-12-16

Hi Eleon. Actually our devices has a current consumption of 35 uA without activati I2C bus and the Accelerometer. With the Accelerometer the current consumption goes up to 55 uA. Actually we have it Low Pass Filter, Low-Power Mode 1 (12-bit resolutio...

User statistics

User Activity

LSM303AGRTR minimun configuration as temperature sensor

How to convert the LSM303AGR Accelerometer temperature from the 2 registers to Celsius Degrees

I want to decrease the power consumption of LIS2DW12. It proposed to sense human motion, and I don´t know if it is better to have a Low Pass Filter or High Pass Filter configured in CTRL6, and what LPM mode I should set in CTRL1. Please see details below:

Re: I want to decrease the power consumption of LIS2DW12. It proposed to sense human motion, and I don´t know if it is better to have a Low Pass Filter or High Pass Filter configured in CTRL6, and what LPM mode I should set in CTRL1. Please see details below: