HiI have an STM32F769 Discovery board (STM32F769I-DISCO) with STLink onboard.STLink works fine but if I try to run my STM32 application STLink reports the MCU is not detected:========Target no device foundError in initializing ST-LINK device.Reason: ...
HiI got an STM32MP157C-DK2 during the Embedded World.But Windows7 isn't detecting the DFU ... It detects only the STLink (UART) ....Same issue in a Ubuntu-16 (which is running in VirtualBox on the same Windows 7)Any suggestion?Regards Francesco
HI allJust to let you know the Teseo-LIV3F firmware (Teseo-LIV3FSW) is available online on www.st.comHave a look at https://www.st.com/content/st_com/en/products/embedded-software/automotive-infotainment-and-telematics-software/teseo-liv3fsw.htmlRega...
Hi allHave a look @https://www.st.com/resource/en/application_presentation/teseo-3-quick-testing-guide.pdfit's an easy way to test the connection to the Teseo III server based Assisted GNSS without special equipment and/or tool.
Teseo-LIV4FM will not be produced any more and all the Teseo-LIV4FM features have been moved on Teseo-LIV4F using dedicated firmwareTo get raw measurement data in RTCM format you have to install the _ME_ firmware available for free @ https://www.st.c...
Question 1:
you can use the command $PSTMNMEAONOFF,0 or $PSTMNMEAONOFF,1 to stop/start the NMEA stream
Question 2:
you can use the command:
$PSTMCFGPORT,0,0,2,115200
$PSTMSAVEPAR*58
$PSTMSRR*49
Regards
Francesco
Hi
Just some questions:
1. Is the platform strongly fixed to the car (without any relative movement between the board and the car)?
2. Are you using ODO signals (and/or SensorOverUart) or are you using DRAW mode?
Thansk
> So I guess GGA messages cannot be sent out at 1Hz rate. Is that correct?
No it isn't.
GGA can run @ 1Hz.... but with this FIX-Rate you are not using the full potentialities the module has.
