About Gussius

Gussius · 2019-11-10

When I try to generate code for SMT32CubdeIDE in HAL from Motor Control Workbench, it always finishes with errors..."Unable to load or decode JSON DB file C:\Users\<user_name>\.stmcufinder\plugins\mcufinder//mcu/mcusFeaturesAndDescription.json"I am h...

Gussius · 2019-11-06

I have made a SM-PMSM project for a hub motor (10 pole pairs). I can compile the generated code in STM32CubeIDE (HAL) but when I run it I always get the fault "Speed feedback" in Motor Control Workbench Monitor.There is 20ms of activity, where there ...

Gussius · 2020-09-10

Thanks a lot for your solution on this @jouko.perkkio .

Gussius · 2019-11-24

I have still had no luck with trying to get this motor going with STEVAL-SPIN3201 and Motor Control Workbench.Here is an image of the motor internals...Any help would still be appreciated.Thanks,Angus.

Gussius · 2019-11-12

Hi Cedric,Thanks again for your assistance.I have opened the IOC file directly in CubeMX and generated the code from there. I don't think this error was having any effect on the generated code. As it always compiled fine anyway. I opened the mcusFeat...

Gussius · 2019-11-12

Hi Cedric,Thanks for your reply.I have opened up the motor and measured the physical angle of the hall sensors, and they are 60 degrees appart from each other.I have probed U and V with CH1 and CH2 and hall sensors digital signals (see image)... The ...

User statistics

User Activity

Unable to load or decode JSON DB file in Motor Control Workbench code generation step.

Speed Feedback fault in Motor Control Workbench Monitor.

Re: Speed Feedback fault in Motor Control Workbench Monitor.

Re: Speed Feedback fault in Motor Control Workbench Monitor.

Re: Unable to load or decode JSON DB file in Motor Control Workbench code generation step.

Re: Speed Feedback fault in Motor Control Workbench Monitor.