About HNass.2

HNass.2 · 2022-11-14

Hello,I have made a custom board for the STM32G070KBT6 MCU to interface with other boards in an embedded project. I have added a mini–USB B connector to the PCB to communicate between the MCU and my computer. In the MCU, I am using one of the USART c...

HNass.2 · 2022-11-15

Thank you @Community member. Yes, I have a common ground connected as well. The peripheral clocks were enabled, and the initialisation code I used was auto generated by the IDE. It seems that I had mis-connected the CTS and RTS lines and didn't cros...

HNass.2 · 2022-11-15

Thank you @Bob S. Rookie error but I hadn't realised I need to cross-over the CTS and RTS cables and I think that was the problem. I believe I was following 'Legacy hardware flow control' (AN0059.0: UART Flow Control (silabs.com)). I've kept the con...

User statistics

User Activity

UART_FLAG_TXE and UART_FLAG_TC not being set and reset during serial UART communication. How can I fix this?

Re: UART_FLAG_TXE and UART_FLAG_TC not being set and reset during serial UART communication. How can I fix this?

Re: UART_FLAG_TXE and UART_FLAG_TC not being set and reset during serial UART communication. How can I fix this?